Panasonic EB-H10 & EB-H105 Programming Guide

BASIC NAM PROGRAMMING

A.	Connect a fully charged battery to the unit (a programming adapter is 
        not required)

B.	To enter NAM mode, turn power ON and within 20 seconds enter the 
        following code:

C.	* 0 # 0 * 0 # 0 * 1 FNC * (note: display will show "A" when pressing 
        [*] and "C" when pressing [#] )

D.	Display will indicate "nA", meaning nam mode.If "nA" does not appear, 
        turn OFF and back ON again, then retry the code.

E.	Basic NAM Programming as follows:

	NOTE 1: if, during programming, any STEP is entered incorrectly, the 
        display and back lights will flash. If so, press and hold [CLR] 
        until the display has completely cleared, then re-enter the correct
	value.

STEP	ACTION			                  TO STORE	DISPLAY
----    ------					------------	----------

 1)	Enter the 5 digit id			[FCN][RCL]01	StorEd	01

 2)	Enter the 10 digit Phone # (MIN)	[FCN][RCL]02	StorEd	02

 3)	Enter the preferred system mark:	[FCN][RCL]03	StorEd	03
	0 for wire line (B system)
	1 for non-wire line (A system)

 4)	Enter the 4 digit Initial paging 	[FCN][RCL]04	StorEd	04
	channel: 0333 for non-wired line (A system)
		 0334 for wired line (B system)

 5)	Enter the 2 digit access overload 	[FCN][RCL]05	StorEd	05
	code: 0 and the last digit of the MIN

 6)	Enter the 2 digit group id		[FCN][RCL]06	StorEd	06

 7)	Enter 2 to 4 digit lock code		[FCN][RCL]07	StorEd	07
 	(by customer request)


F.	To burn NAM press [FCN][RCL] * *    the display will indicate "stored"

G.	Press [END] to complete basic NAM programming.

