		      Easter Egg Bomb with delay fuse
				 By FootMaan 
			 email: 0101@geocities.com



Disclaimer:
	The intention of this text is of educational value only.
	Creation of such a device can cause great bodily harm or 
	even death. Use this information at your own risk.



Equipment:
	(1) Large easter egg (larger half holds 1/3 of a cup; smaller one holds 1/4) 
	(1) Cigarette
	(1) Fast burning fuse (1 1/2 inches)
	(1) Paper towl 
	(1) Drill with small bit
	(1) Explosive powder (black powder / solidox / etc.)
	(1) Super glue
	(1) Thin role of masking tape
	
Instructions:
	In the smaller half of the egg, drill a small hole in the top. This hole
	will help air circulate whitin the egg and help the cigarette's smoke get
	out. Next, take the larger half of the egg and pour ~ 1/3 of a cup (or till                                                     
	full) of explosive powder in it. Now, Glue around the edge of the larger
	half and place the paper towl on top of were you glued making sure the paper 
	towl is taught; then cut the exess away from the egg. This will help the 
	powder from igniting prematurely if the cigarette comes near and keep the 
	the powder in the larger half of the egg. Now, Put a small hole large
	enough for the fuse to fit through in the towl then put the fuse in the hole and                                        
	making sure the bottom of the fuse reaches the powder beneath the paper towl.
	Next, take the cigarette and cut the filter off (make sure the cigarette can fit                                                        
	horrizantaly inside the smaller half of the egg by cutting the exess off also) 
	and put a hole for the fuse on the far end of one side of the cigarette; then                                           
	carefully fit the fuse through the hole you made and make sure there is a little
	bit of the fuse sticking out from the other side of the cigarette. Now, take the                                        
	tape and tape the upper part of the fuse (the part sticking out on other side of 
	the cigarette) to the cigarette.

Usage:
	To use, simply light the oppisite end of the cigarette the fuse has been placed
	on and carefully put the smaller half of the egg back onto the larger one. Even
	though I said earlier that the paper towl might protect the cigarette from igniting 
	the explosive powder prematurely, the egg should be placed on its side so gravity 
	will not force the cigarette onto the partition between the explosive powder and 
	the cigarette (the paper towl) just to be safe. After the cigarette has burned down
	to the place were you put the fuse through, the fuse should ignite and several 
	seconds later the fuse should ignite the powder causing the egg to explode. I am
	not aware of the length of time required for this to happen because I have never 
	built one of these before but I hope to some time in the futer.

Explosives: 
	Finding explosive powder required to build an egg bomb is easy; you can buy gun 
	powder at a gun store or make some type of powder at home. To make a solidOx 
	explosive folow these inscructions:

	  If you baught solidOx pellets, just mix 1/6 of a cup with 1/6 of a cup of 
	  table sugar. If you are using sticks, grind them up with a morder and pestal 
	  to create powder then mix 1/6 of a cup with 1/6 of a cup of table sugar. After
	  this, the mixture will  be ready to be put in the egg. SolidOx can be baught
	  at most hardware stores and some stores like Kmart.



	
	 
