SEAGATE TECHNOLOGY, INC. Customer Technical Support FAX Network +1 408 438-8137 Customer Technical Support Bulletin Boards (300-9600, 8-N-1) ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÂÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ³ United States +1 408 438-8771 ³ United Kingdom +44 628 478011 ³ ÃÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÅÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ´ ³ Germany +49 89 140-9331 ³ Singapore +65 227-2217 ³ ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ (C)opyright 1991 ST-1102A and ST1102A-32 ÍÍÍPWAÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ Ú....................¿ /ÄÄÄÄÄÄÄÄÄ\ ...................1 ³ O O O O ³ 1 o o 2 ÄÄÄÄÄÄÄÄ¿ À Cable Connector ÀÄ5ÄGÄGÄ12Ù 3 o o 4 ÄÄÄÄÄÄ¿ ³ 5 o o 6 ÄÄÄÄ¿ ³ ³ 7 o o 8 ÄÄ¿ ³ ³ ³ 9 o o 10 ¿ ³ ³ ³ ³ 1=closed 0=open ³ ³ ³ ³ ÀÄÄ Life-Test (Factory use) ³ ³ ³ ÀÄÄÄÄ Master on (Slave off) ÄÄÄÄ 1 1 0 ³ ³ ÀÄÄÄÄÄÄ Slave Present ÄÄÄÄÄÄÄÄÄÄÄÄ 0 1 0 ³ ÀÄÄÄÄÄÄÄÄ Reserved ÀÄÄÄÄÄÄÄÄÄÄ Remote LED S M S i a l n s a g t v l e e e r ST-1102A UNFORMATTED CAPACITY (MB) ________________N/A FORMATTED CAPACITY (xx/17 SECTORS) (MB) __89.1 ACTUATOR TYPE ____________________________VOICE COIL TRACKS ___________________________________10,240 CYLINDERS __PHYSICAL/LOGICAL______________NA/1,024 HEADS ______PHYSICAL/LOGICAL______________5/10 DISCS ____________________________________3 MEDIA TYPE _______________________________THIN FILM RECORDING METHOD _________________________ZBR RLL (2,7) TRANSFER RATE INTERNAL (mbits/sec) _______8.2/10/12 SPINDLE SPEED (RPM) ______________________3,528 AVERAGE LATENCY (mSEC) ___________________8.5 BUFFER ___________________________________8 or 32 Kbyte Read Look-Ahead, Non-Adaptive, Single-Segmented Buffer INTERFACE ________________________________AT BUS SECTORS PER DRIVE ________________________174,080 TPI (TRACKS PER INCH) ____________________1,300 BPI (BITS PER INCH) ______________________21,600 AVERAGE ACCESS (ms) ______________________19 SINGLE TRACK SEEK (ms) ___________________8 MAX FULL SEEK (ms) _______________________40 MTBF (power-on hours) ____________________150,000 POWER REQUIREMENTS: +12V START-UP (amps) _2.0 +12V TYPICAL (amps) __0.7 +5V START-UP (amps) __0.63 +5V TYPICAL (amps) ___0.4 TYPICAL (watts) ______8 MAXIMUM (watts) ______ BUFFERED STEP PULSE RATE (micro sec) _____ WRITE PRECOMP (cyl) ______________________N/A REDUCED WRITE CURRENT (cyl) ______________N/A LANDING ZONE (cyl) _______________________AUTO PARK IBM AT DRIVE TYPE ________________________* * MAY REQUIRE FORMATTING AND PARTITIONING SOFTWARE. ALSO, CHECK TO SEE IF YOUR CMOS SETUP HAS A "CUSTOM" OR "USER DEFINABLE" DRIVE TYPE AVAILABLE. Translation to use: 1024 cyl, 10 heads, 17 sectors = 89,128,960 Note: A "custom" or "user-definded" CMOS drivetype may ask for a numerical value for the Write Precompensation cylinder and for the Landing Zone cylinder. A basic rule-of-thumb for drive models that do not require the old Write Precomp technique or a Landing Zone because they are Auto-Parking is to add 1 to the cylinder value being used. As an example: If cylinders equaled 820, then both Write Precomp and Landing Zone would be entered as 821. Some BIOS will convert this to 65535 or -1, which are functionally equivalent to "none (not used)". PHYSICAL/LOGICAL equivalent to NATIVE/TRANSLATION ZBR = Zone Bit Recording = Variable sectors per track Already low-level formatted at the factory. Since a User-definable or Custom translation geometry may be used, it is imperative that the values be written down and kept with your permanent records for retrieval in the event of CMOS battery failure. Seagate reserves the right to change, without notice, product offerings or specifications.