09/12/92 ë The BOM Squad ë ë presents ë --=* EZ Napalm *=-- By Neuromancer Disclaimer: The information contained in this file is intended for information purposes only. The author is not responsible for the use/misuse of this information. Once it is in your hands I urge you to use it responsibly. Please share this file with your friends and distribute it widely. Creating the mixture: Here is a cheap and easy way to make yourself a very effective napalm substitute. You'll need gasoline, styrofoam, and a pail. I use a metal pail, but anything that can hold up to gasoline is good. Start with enough gasoline to cover the bottom of the pail about a half inch deep. Then start adding the styrofoam. The gasoline will sort of soak it up. Just keep adding more and more styrofoam, putting it in slowly, waiting for it to be absorbed by the gasoline, until it wont soak up any more. It will take quite a bit of styrofoam, so make sure you have alot on hand. When the gasoline stops soaking up the styrofoam it's done. Pour off the mixture into a glass jar for storage. Avoid getting the mixture on your skin because it will cause serious irritation. Wash your hands when you're through to avoid getting it into your eyes, etc. Voila! You have some napalm. Practical application: The mixture can be used as a throwing weapon. To make a neat little projectile take a glass bottle and score the outside with a glass cutter in a checkerboard pattern. Pour the mixture into the bottle. Put a gasoline soaked rag into the neck of the bottle. Light the rag and throw the bottle. The reason for the scoring is to make the bottle break easily on impact, so that when it is thrown the mixture spreads into a wide radius and gets ignited by the burning rag. This stuff does a nasty job on car paint... just pour it onto your victim's car and light. For a neat timed ignition system, see below. If you used the right amount of styrofoam this stuff will burn for a looooong time leaving much expensive damage in it's wake. Neat timed ignition system: To make this you'll need a cigarette, matches, and some masking tape. Take about a 2 inch length of tape and lay it down flat. Line up matches side by side perpendicular to the length of the tape, covering about half . ooooooooooooo |||||||||||||----------------| /|||||||||||||----------------|\ / ||||||||||||| \ /_ matches \_ tape Fig. 1 ------ Wrap the tape/matches around the cigarette so the match heads are about an eighth of an inch up from the filter. You can spread the mixture on whatever it is you are going to be burning and lay the igniter so that the cigarette is away from the mixture and the matches are just at the edge. Light the cigarette first! It will take some time for the head of the cigarette to reach the matches, thus igniting them, thus igniting the mixture. It takes some practice to get the placement right, but when you have it down it gives you time to get away. I actually got this idea from the news. It was used by an accomplished arsonist in setting gasoline fires. Isn't the media wonderful? That's all for now. Above all, have fun! peace, Neuromancer